![]() ![]() ![]() ![]() Type J on the command line and press enter then select complete geometry and press enter again. Trim all the geometries to make it look like the image below. Now apply this fillet at the intersections of the circle with R2.5 and R22.5 as shown in the image below. You will get an array like the one shown in the image below.ĭelete the biggest circle and select FILLET command now enter R on the command line and type 7 as the fillet radius. Now specify the center of the largest circle as the center of the array and enter 4 in the Number of Items field. Select Polar Array from the Modify panel of Home tab and select two small circles on the top of geometry. Create the following circles using CIRCLE command from draw panel of home tab, make sure circle with radius 2.5 units has its center on the circumference of the circle with radius 26 units. ![]()
0 Comments
Leave a Reply. |